Search


Current filters:
Start a new search
Add filters:

Use filters to refine the search results.


Results 11-20 of 46 (Search time: 0.016 seconds).
Item hits:
TitleAuthor(s)SourcePage(s)
Evaluation of drilled hole quality of Al-Si alloy/fly ash composites produced by powder metallurgical techniqueJailani, H Siddhi; Rajadurai, A; Mohan, B; Sornakumar, TIJEMS Vol.22(4) [August 2015]414-420
Taguchi-Grey computation methodology for optimum multiple performance measures on machining titanium alloy in WEDM processRamamurthy, A; Sivaramakrishnan, R; Muthuramalingam, TIJEMS Vol.22(2) [April 2015]181-186
Optimization of cutting tool geometry based on flank wear – DoE, PSO and SAA approachTamizharasan, T; Barnabas, J KingstonIJEMS Vol.21(5) [October 2014]543-556
Fuzzy logic and regression modelling of cutting parameters in drilling using vegetable based cutting fluidsKuram, Emel; Ozcelik, BaburIJEMS Vol.20(1) [February 2013]51-58
Machinability of NdFeB magnet via wire and sinking EDM methodsLi, Li; Cheng, Xiang; Sima, Zhongwen; Niu, ZongweiIJEMS Vol.22(4) [August 2015]407-413
Tool life performances, wear mechanisms and surface roughness characteristics when turning austenised and quenched AISI 52100 bearing steel with ceramics and CBN/TiC cutting toolsMotorcu, Ali RizaIJEMS Vol.18(2) [April 2011]137-146
Analysis and evaluation of heat affected zones in electric discharge machining of EN-31 die steelChoudhary, Rajesh; Kumar, H; Garg, R KIJEMS Vol.17(2) [April 2010]91-98
Effects of sulfurization of grinding wheels on internal cylindrical grinding of Titanium Grade 2®Nadolny, Krzysztof; Kapłonek, Wojciech; Wojtewicz, MichalIJEMS Vol.20(2) [April 2013]108-124
Elucidating the effect of electrical discharge machining parameters on the surface roughness of AISI D6 tool steel using response surface methodPourasl, Hamed H; Barenji, Reza Vatankhah; Khojastehnezhad, Vahid MIJEMS Vol.24(1) [February 2017]83-90
Effect of cutting parameters on machining surface and cutting tool in milling of Ti-6Al-4V alloyÇelik, Yahya Hışman; Karabiyik, AhmetIJEMS Vol.23(5) [October 2016]349-356